Like CV joints, universal joints (U-joints) are located at each end of a drive shaft and allow the shaft to operate at a variable angle with the item it is driving. Universal joints perform the same basic function as CV joints but CV joints have a wider range of operation.

The distributor is driven by the engine's camshaft and is responsible for timing the spark and distributing it to the correct cylinder. The distributor cap contains a rotor that connects the ignition coil (and its high voltage) to the proper cylinder at the proper point in the stroke cycle.

An overcooled engine is less efficient. During the power stroke, combustion heat pushes down the piston. If too much of this heat is lost to the cooling system, the fuel might not combust completely and contaminate the engine's lubricating oil diminishing its lubricating ability. Incomplete combustion of fuel also negatively affects the engine's fuel efficiency and power output.

Suspension springs are made with wide gap coils of rigid steel cable and both hold the vehicle chassis up off the ground and absorb energy from wheel movement making for a smoother ride.

In engine lubrication, oil remains in the oil pan until the engine is turned on. It then gets sucked up the pickup tube by the oil pump and pressurized. This pressure is moderated by the pressure relief valve and the oil is fed through the oil filter into the engine to lubricate it.