The ignition coil steps up the 12 volts available from the battery or alternator to a voltage of 30,000 or more volts at the spark plug. Converting a lower voltage input into a higher voltage output makes the ignition coil a step-up transformer.

Both drum brake and disc brake assemblies use friction to stop a car's wheels from turning but each do it in a slightly different way. A drum brake assembly uses a large iron drum attached to the wheel and brake shoes that press against the drum to slow the rotation of the drum and, consequently, the wheel. A disc brake assembly employs friction in the same way as a drum brake but instead uses a rotor, also attached to the wheel, and two brake pads that squeeze against the surface of the rotor.

Cylinder number and arrangement depends on the purpose of the engine. Smaller (four and six cylinder) engines in front-wheel drive vehicles often use an inline design which orients cylinders vertically over the crankshaft and aligns them in a row. Other common orientations are a horizontal/opposed design which places cylinders flat facing each other with the crankshaft between them and a V-type design common in six and eight cylinder engines that features one cylinder head per block of cylinders oriented at a 60 to 90 degree angle to each other with the crankshaft at the bottom of the V.

A radial arrangement places cylinders in a circle around the crankshaft and is used almost exclusively in aircraft engines.

Actuators receive signals from the PCM and carry out adjustments needed based on the data the PCM received from the sensors.