A v-arrangement has two rows of cylinders in a V-shaped block with a crankshaft at the bottom of the V. Any even number of cylinders is possible in this configuration from the V-2 that's commonly used in motorcycles up to V-12 or bigger for large trucks. The V design produces a shorter engine than an in-line cylinder configuration and allows for better air-fuel distribution.

The fuel injector sprays fuel into the air stream that's being fed into the cylinder head via the intake valve. The timing and amount of fuel are regulated by the powertrain control module (PCM) which is the main computer that controls engine and transmission functions.

Like CV joints, universal joints (U-joints) are located at each end of a drive shaft and allow the shaft to operate at a variable angle with the item it is driving. Universal joints perform the same basic function as CV joints but CV joints have a wider range of operation.

Because a compressed spring will ex­tend violently, shock absorbers must be used to dampen the spring’s compression and extension cycles. Struts combine the spring and shock into one unit

Actuators receive signals from the PCM and carry out adjustments needed based on the data the PCM received from the sensors.