ASVAB Automotive Information Practice Test 320200 Results

Your Results Global Average
Questions 5 5
Correct 0 3.23
Score 0% 65%

Review

1

Which of the following regulates the opening and closing of the intake and exhaust valves in each cylinder in time with the motion of the piston?

65% Answer Correctly

connecting arm

crankshaft

halfshaft

camshaft


Solution

The camshaft is linked to the crankshaft through a timing belt and regulates the opening and closing of the intake and exhaust valves in each cylinder in time with the motion of the piston. An engine designated OverHead Camshaft (OHC) locates the camshaft in the cylinder head. An engine with Double OverHead Camshaft (DOHC) has two camshafts, one to regulate the intake valves and one to regulate the exhaust valves.


2

Ignition timing is measured in number of degrees:

59% Answer Correctly

before bottom dead center

before top dead center

after bottom dead center

after top dead center


Solution

Ignition timing defines the point in time at the end of the compression stroke that the spark plug fires. Measured in number of degrees before top dead center (BTDC), the exact point that the spark plugs initiate combustion varies depending on the speed of the engine. The timing is advanced (the spark plugs fire a few more degrees BTDC) when the engine is running faster and retarded when it's running slower.


3

A __________ is designed to drive a pair of wheels while allowing them to rotate at different speeds.

69% Answer Correctly

transfer case

CV joint

half shaft

differential


Solution

A differential is designed to drive a pair of wheels while allowing them to rotate at different speeds. A transaxle is a transmission that incorporates the differential in one package. Most front-wheel drive cars use a transaxle while rear-wheel drive cars use a transmission and separate differential connected via a drive shaft. The differential is incorporated into the drive axle which splits engine power delivered by the drive shaft between the two drive wheels. All-wheel drive cars typically use a transaxle that includes an output shaft to the rear differential.


4

Gases from combustion are pushed out through the exhaust valve as the piston travels up the cylinder to top dead center. This describes which engine stroke?

67% Answer Correctly

intake

power

compression

exhaust


Solution

During the exhaust stroke, just before the piston reaches bottom dead center the exhaust valve opens. The resulting gases from combustion are then pushed out through the exhaust valve as the piston travels up the cylinder to top dead center, completing stroke four of the four-stroke piston cycle.


5

What is the name of the proper ratio of air to fuel necessary so that an engine burns all fuel with no excess air?

62% Answer Correctly

ignition ratio

combustion ratio

stoichiometric ratio

residual ratio


Solution

The stoichiometric ratio defines the proper ratio of air to fuel necessary so that an engine burns all fuel with no excess air. For gasoline fuel, the stoichiometric ratio is about 14.7:1 or for every one gram of fuel, 14.7 grams of air are required. Too much air results in a lean air-fuel mixture that burns more slowly and hotter while too much fuel results in a rich mixture that burns quicker and cooler.