A v-arrangement has two rows of cylinders in a V-shaped block with a crankshaft at the bottom of the V. Any even number of cylinders is possible in this configuration from the V-2 that's commonly used in motorcycles up to V-12 or bigger for large trucks. The V design produces a shorter engine than an in-line cylinder configuration and allows for better air-fuel distribution.

The primary difference between internal and external combustion engines lies in where the power is developed. In an internal combustion engine fuel is ignited and burned inside the same container where the power is developed while in an external combustion engine the fuel is ignited outside the engine and the resulting power sent to it.

The thermostat controls coolant (and, through it, engine) temperature by regulating the flow of coolant through the radiator. A bypass tube allows coolant to bypass the radiator and flow back into the water pump when its temperature is low enough that the thermostat is closed.

An automobile's electrical system runs on DC power and the bulk of that power is supplied by the battery. The alternator converts the motion of the rotor into AC power which is then fed through the rectifier to convert it to DC power that both the car and the battery can use.

Ignition timing defines the point in time at the end of the compression stroke that the spark plug fires. Measured in number of degrees before top dead center (BTDC), the exact point that the spark plugs initiate combustion varies depending on the speed of the engine. The timing is advanced (the spark plugs fire a few more degrees BTDC) when the engine is running faster and retarded when it's running slower.