Modern car engines are cooled by liquid which circulates through the engine block and cylinder heads absorbing excess heat. This liquid is made up of half water and half antifreeze (commonly, ethylene glycol) which both keeps the water from freezing at low temperatures and raises its boiling point making heat transfer more efficient.

In a four-stroke cycle engine there is always one piston delivering power, one exhausting gases, one drawing in the air-fuel mixture, and one compressing that mixture.

Fuel injection has replaced the carburetor as the primary automobile fuel delivery system. The main difference between the fuel injector and the carburetor is that fuel injection atomizes the fuel by forcibly pumping it through a small nozzle under high pressure while a carburetor relies on suction to draw fuel into an accelerated intake air stream.

Actuators receive signals from the PCM and carry out adjustments needed based on the data the PCM received from the sensors.

The cast iron exhaust manifolds collect engine exhaust gas from multiple cylinder exhaust valves and deliver it to the exhaust pipe. Exhaust manifolds can be generic or specially tuned (header pipes) to the engine. Header pipes deliver higher performance but are more expensive and less durable.