ASVAB Automotive Information Practice Test 596113 Results

Your Results Global Average
Questions 5 5
Correct 0 3.02
Score 0% 60%

Review

1

The wheel __________ is the mounting point for the wheel and tire assembly.

66% Answer Correctly

base

hub

shaft

knuckle


Solution

The wheel hub is the mounting point for the wheel and tire assembly. The wheel hub can rotate while being held stable by the steering knuckle which applies the motion of the control arms to the wheels.


2

__________ are made with wide gap coils of rigid steel cable and both hold the vehicle chassis up off the ground and absorb energy from wheel movement making for a smoother ride.

67% Answer Correctly

control arms

shock absorbers

suspension springs

ignition coils


Solution

Suspension springs are made with wide gap coils of rigid steel cable and both hold the vehicle chassis up off the ground and absorb energy from wheel movement making for a smoother ride.


3

Which engine stroke starts with the piston at top dead center?

61% Answer Correctly

exhaust stroke

power stroke

compression stroke

intake stroke


Solution

The four-stroke piston cycle of internal combustion engines starts with the piston at top of the cylinder head (top dead center or TDC) during the intake stroke. The piston moves downward in the cylinder creating a vacuum that pulls an air-fuel mix into the combustion chamber through the now open intake valve.


4

Piston rings are responsible for which of the following?

50% Answer Correctly

containing combustion

connecting the piston to the camshaft

regulating oil distribution inside the cylinder

connecting the piston to the spark plug


Solution

Cylinders act as a guide for the pistons that translate the heat energy of combustion into the mechanical energy necessary to move a vehicle. Piston rings seal the piston to the cylinder to contain combustion gases and also regulate the oil distribution between the piston and cylinder wall. A cylinder head closes in the top of the cylinder forming the combustion chamber which is sealed by a head gasket (head). The head provides space for air and fuel intake valves, exhaust valves, and mounts for spark plugs and fuel injectors.


5

Which of the following is not a primary function of a vehicle's lubrication system?

62% Answer Correctly

cools engine parts

increases fuel economy

clean contaminants

quiets engine noise


Solution

The lubrication system lubricates engine components by putting an oil film between them to reduce friction and smooth engine operation, cools by absorbing heat from engine parts, seals the pistons and cylinders to contain combustion, cleans contaminants, and quiets engine noise.