The transfer case splits engine power between the front and rear axles of four-wheel drive vehicles.

The intake manifold distributes outside air to the intake ports on the cylinder heads. The intake air filter removes any airborne contaminants before the air enters the engine.

Both drum brake and disc brake assemblies use friction to stop a car's wheels from turning but each do it in a slightly different way. A drum brake assembly uses a large iron drum attached to the wheel and brake shoes that press against the drum to slow the rotation of the drum and, consequently, the wheel. A disc brake assembly employs friction in the same way as a drum brake but instead uses a rotor, also attached to the wheel, and two brake pads that squeeze against the surface of the rotor.

The stroke cycle of an engine is governed by the crankshaft which serves to regulate the firing order of the cylinders. All cylinders are not on the same stroke at the same time and correct firing order is important to balance engine operation and minimize vibrations. A common firing order for four-cylinder engines is 1-3-4-2 which indicates that cylinders 1 and 3 fire (power stroke)together and cylinders 4 and 2 fire together.

Constant velocity (CV) joints are located at both ends of a half shaft and their purpose is to transfer the torque from the transmission to the drive wheels at a constant speed while accomodating the up and down movement of the suspension. The inner CV joint connects the shaft to the transmission and the outer CV joint connects the shaft to the wheel.