Both drum brake and disc brake assemblies use friction to stop a car's wheels from turning but each do it in a slightly different way. A drum brake assembly uses a large iron drum attached to the wheel and brake shoes that press against the drum to slow the rotation of the drum and, consequently, the wheel. A disc brake assembly employs friction in the same way as a drum brake but instead uses a rotor, also attached to the wheel, and two brake pads that squeeze against the surface of the rotor.

Preignition results from the buildup of fuel deposits and/or oil in the combustion chamber. These deposits increase chamber pressure and reduce heat tranfer to the coolant. The trapped heat then raises the temperature of the air-fuel mix to the point that it combusts before ignition.

The combustion chamber is located in the cylinder head and contains the combustion of the air-fuel mixture. This mixture is delivered by an intake valve and the waste gases from combustion are removed from the combustion chamber by the exhaust valve.

A head gasket is a gasket that sits between the engine block and cylinder heads to seal the cylinders to ensure maximum compression and avoid leakage of coolant or engine oil into the cylinders.

During the power stroke, just before the piston reaches top dead center, the spark plug fires and ignites the compressed air-fuel mixture. The resulting expansion due to combustion pushes the piston back down the cylinder toward bottom dead center.