ASVAB Automotive Information Practice Test 665135 Results

Your Results Global Average
Questions 5 5
Correct 0 3.08
Score 0% 62%

Review

1

Which of the following is not a characteristic of disc brakes?

57% Answer Correctly

uses brake pads

uses brake shoes

uses a rotor

newer brake system


Solution

Both drum brake and disc brake assemblies use friction to stop a car's wheels from turning but each do it in a slightly different way. A drum brake assembly uses a large iron drum attached to the wheel and brake shoes that press against the drum to slow the rotation of the drum and, consequently, the wheel. A disc brake assembly employs friction in the same way as a drum brake but instead uses a rotor, also attached to the wheel, and two brake pads that squeeze against the surface of the rotor.


2

The __________ splits engine power between the front and rear axles of four-wheel drive vehicles.

61% Answer Correctly

transmission linkage

transfer case

universal joint

master cylinder


Solution

The transfer case splits engine power between the front and rear axles of four-wheel drive vehicles.


3

What is the pimary advantage of using power brakes on a vehicle?

62% Answer Correctly

utilizes battery power to assist in braking

allows the use of antilock brakes

requires less brake fluid to operate the braking system

provides higher hydraulic pressure in the braking system


Solution

Power brakes multiply the force a driver applies to the brake pedal using a vacuum booster connected to the engine intake manifold. This provides for much higher hydraulic pressure in the braking system than could be generated by the driver alone. Antilock brakes (ABS) use speed sensors and adjust the brake pressure at each wheel to prevent skidding and allow the driver more steering control in slippery conditions.


4

Which of the following is not a function of the oil pan?

62% Answer Correctly

feeds the oil pump

cools engine oil

acts as the engine oil reservoir

screens debris from oil


Solution

The oil pan contains the engine oil reservoir of from four to six quarts of oil and feeds the oil pump through the oil pickup tube. An oil strainer floats at the top of the oil in the oil pan and screens debris from the oil before feeding it to the oil pump.


5

The wheel __________ is the mounting point for the wheel and tire assembly.

66% Answer Correctly

shaft

hub

knuckle

base


Solution

The wheel hub is the mounting point for the wheel and tire assembly. The wheel hub can rotate while being held stable by the steering knuckle which applies the motion of the control arms to the wheels.