A v-arrangement has two rows of cylinders in a V-shaped block with a crankshaft at the bottom of the V. Any even number of cylinders is possible in this configuration from the V-2 that's commonly used in motorcycles up to V-12 or bigger for large trucks. The V design produces a shorter engine than an in-line cylinder configuration and allows for better air-fuel distribution.

Cylinders act as a guide for the pistons that translate the heat energy of combustion into the mechanical energy necessary to move a vehicle. Piston rings seal the piston to the cylinder to contain combustion gases and also regulate the oil distribution between the piston and cylinder wall. A cylinder head closes in the top of the cylinder forming the combustion chamber which is sealed by a head gasket (head). The head provides space for air and fuel intake valves, exhaust valves, and mounts for spark plugs and fuel injectors.

Constant velocity (CV) joints are located at both ends of a half shaft and their purpose is to transfer the torque from the transmission to the drive wheels at a constant speed while accomodating the up and down movement of the suspension. The inner CV joint connects the shaft to the transmission and the outer CV joint connects the shaft to the wheel.

Normal combustion in an engine is initiated by a spark plug and results in the complete burning of the air-fuel mixture. If combustion is initiated by a source other than the spark plug, by a hot spot in the cylinder or combustion chamber for example, pre-ignition results. Detonation results if the air-fuel mixture explodes instead of burning. Detonation can cause extremes in pressure in the combustion chamber leading to engine damage.

Maintaining proper synchronization between the rotation of the camshaft and the rotation of the crankshaft is critical to ensure that the engine's valves open and close at the proper times during each cylinder's intake and exhaust strokes.