The ignition coil is a high-voltage transformer made up of two coils of wire. The primary coil winding is the low-voltage winding and has relatively few turns of heavy wire. The secondary coil winding is the high-voltage winding that surrounds the primary and is made up of thousands of turns of fine wire. Current flows from the battery through the primary coil winding which creates a changing magnetic field inside the secondary coil. This induces a very high-voltage current in the secondary coil which it feeds to the distributor.

Constant velocity (CV) joints are located at both ends of a half shaft and their purpose is to transfer the torque from the transmission to the drive wheels at a constant speed while accomodating the up and down movement of the suspension. The inner CV joint connects the shaft to the transmission and the outer CV joint connects the shaft to the wheel.

A v-arrangement has two rows of cylinders in a V-shaped block with a crankshaft at the bottom of the V. Any even number of cylinders is possible in this configuration from the V-2 that's commonly used in motorcycles up to V-12 or bigger for large trucks. The V design produces a shorter engine than an in-line cylinder configuration and allows for better air-fuel distribution.

Preignition results from the buildup of fuel deposits and/or oil in the combustion chamber. These deposits increase chamber pressure and reduce heat tranfer to the coolant. The trapped heat then raises the temperature of the air-fuel mix to the point that it combusts before ignition.

Combustion is the burning of an air-fuel mixture to provide energy. It requires the presence of air, fuel, and a heat source to ignite the air-fuel mixture. In the internal combustion engine that powers automobiles and trucks the combustion happens inside the engine utilzing a fuel like gasoline, diesel fuel, or natural gas.