The primary difference between internal and external combustion engines lies in where the power is developed. In an internal combustion engine fuel is ignited and burned inside the same container where the power is developed while in an external combustion engine the fuel is ignited outside the engine and the resulting power sent to it.

Cylinders act as a guide for the pistons that translate the heat energy of combustion into the mechanical energy necessary to move a vehicle. Piston rings seal the piston to the cylinder to contain combustion gases and also regulate the oil distribution between the piston and cylinder wall. A cylinder head closes in the top of the cylinder forming the combustion chamber which is sealed by a head gasket (head). The head provides space for air and fuel intake valves, exhaust valves, and mounts for spark plugs and fuel injectors.

The steering linkage is a system of pivots and connecting parts between the steering gear and the control arms. The steering linkage transfers the motion of the steering gear output shaft to the steering arms that turn the wheels.

In engine lubrication, oil remains in the oil pan until the engine is turned on. It then gets sucked up the pickup tube by the oil pump and pressurized. This pressure is moderated by the pressure relief valve and the oil is fed through the oil filter into the engine to lubricate it.

A half shaft is a drive axle that extends from a transaxle or differential to one of the drive wheels. There are two half shafts per drive axle, one for each wheel, each doing "half" the job.