An automobile's electrical system runs on DC power and the bulk of that power is supplied by the battery. The alternator converts the motion of the rotor into AC power which is then fed through the rectifier to convert it to DC power that both the car and the battery can use.

Combustion is the burning of an air-fuel mixture to provide energy. It requires the presence of air, fuel, and a heat source to ignite the air-fuel mixture. In the internal combustion engine that powers automobiles and trucks the combustion happens inside the engine utilzing a fuel like gasoline, diesel fuel, or natural gas.

Cylinder number and arrangement depends on the purpose of the engine. Smaller (four and six cylinder) engines in front-wheel drive vehicles often use an inline design which orients cylinders vertically over the crankshaft and aligns them in a row. Other common orientations are a horizontal/opposed design which places cylinders flat facing each other with the crankshaft between them and a V-type design common in six and eight cylinder engines that features one cylinder head per block of cylinders oriented at a 60 to 90 degree angle to each other with the crankshaft at the bottom of the V.

Cylinders act as a guide for the pistons that translate the heat energy of combustion into the mechanical energy necessary to move a vehicle. Piston rings seal the piston to the cylinder to contain combustion gases and also regulate the oil distribution between the piston and cylinder wall. A cylinder head closes in the top of the cylinder forming the combustion chamber which is sealed by a head gasket (head). The head provides space for air and fuel intake valves, exhaust valves, and mounts for spark plugs and fuel injectors.

Both drum brake and disc brake assemblies use friction to stop a car's wheels from turning but each do it in a slightly different way. A drum brake assembly uses a large iron drum attached to the wheel and brake shoes that press against the drum to slow the rotation of the drum and, consequently, the wheel. A disc brake assembly employs friction in the same way as a drum brake but instead uses a rotor, also attached to the wheel, and two brake pads that squeeze against the surface of the rotor.