ASVAB Automotive Information Practice Test 875038 Results

Your Results Global Average
Questions 5 5
Correct 0 3.55
Score 0% 71%

Review

1

What's the name of the low-voltage winding in the ignition coil?

57% Answer Correctly

tertiary coil winding

primary coil winding

secondary coil winding

distributor coil winding


Solution

The ignition coil is a high-voltage transformer made up of two coils of wire. The primary coil winding is the low-voltage winding and has relatively few turns of heavy wire. The secondary coil winding is the high-voltage winding that surrounds the primary and is made up of thousands of turns of fine wire. Current flows from the battery through the primary coil winding which creates a changing magnetic field inside the secondary coil. This induces a very high-voltage current in the secondary coil which it feeds to the distributor.


2

The catalytic converter output consists primarily of:

65% Answer Correctly

carbon monoxide

water and carbon dioxide

oxygen

gasoline


Solution

The catalytic converter converts pollutants in exhaust gas into less pollutant substances like carbon dioxide and water.


3

The piston moves downward in the cylinder creating a vacuum that pulls an air-fuel mix into the combustion chamber. This describes which engine stroke?

68% Answer Correctly

exhaust

compression

power

intake


Solution

The four-stroke piston cycle of internal combustion engines starts with the piston at top of the cylinder head (top dead center or TDC) during the intake stroke. The piston moves downward in the cylinder creating a vacuum that pulls an air-fuel mix into the combustion chamber through the now open intake valve.


4

When a car engine is running, what provides electrical current to recharge the battery and power the electrical system?

84% Answer Correctly

camshaft

battery

alternator

solenoid


Solution

Once the engine is running, the alternator provides electrical current to recharge the battery and power the electrical system. The alternator is driven by the engine's crankshaft and produces alternating current (AC) which is then fed through a rectifier bridge to convert it to the direct current (DC) required by the electrical system. A voltage regulator controls the output of the alternator to maintain a consistent voltage (approx. 14.5 volts) in the electrical system regardless of load.


5

Which of the following cylinder arrangement would be most common in an eight cylinder engine?

80% Answer Correctly

opposed

V-type

vertical

inline


Solution

Cylinder number and arrangement depends on the purpose of the engine. Smaller (four and six cylinder) engines in front-wheel drive vehicles often use an inline design which orients cylinders vertically over the crankshaft and aligns them in a row. Other common orientations are a horizontal/opposed design which places cylinders flat facing each other with the crankshaft between them and a V-type design common in six and eight cylinder engines that features one cylinder head per block of cylinders oriented at a 60 to 90 degree angle to each other with the crankshaft at the bottom of the V.