The primary difference between internal and external combustion engines lies in where the power is developed. In an internal combustion engine fuel is ignited and burned inside the same container where the power is developed while in an external combustion engine the fuel is ignited outside the engine and the resulting power sent to it.

In engine lubrication, oil remains in the oil pan until the engine is turned on. It then gets sucked up the pickup tube by the oil pump and pressurized. This pressure is moderated by the pressure relief valve and the oil is fed through the oil filter into the engine to lubricate it.

Constant velocity (CV) joints are located at both ends of a half shaft and their purpose is to transfer the torque from the transmission to the drive wheels at a constant speed while accomodating the up and down movement of the suspension. The inner CV joint connects the shaft to the transmission and the outer CV joint connects the shaft to the wheel.

A v-arrangement has two rows of cylinders in a V-shaped block with a crankshaft at the bottom of the V. Any even number of cylinders is possible in this configuration from the V-2 that's commonly used in motorcycles up to V-12 or bigger for large trucks. The V design produces a shorter engine than an in-line cylinder configuration and allows for better air-fuel distribution.

The crankshaft converts the reciprocating motion of the piston into the rotational motion that's used to power the vehicle and its components.