| Your Results | Global Average | |
|---|---|---|
| Questions | 5 | 5 |
| Correct | 0 | 3.62 |
| Score | 0% | 72% |
A cylinders acts as a guide for a:
driveshaft |
|
camshaft |
|
valve |
|
piston |
Cylinders act as a guide for the pistons that translate the heat energy of combustion into the mechanical energy necessary to move a vehicle. Piston rings seal the piston to the cylinder to contain combustion gases and also regulate the oil distribution between the piston and cylinder wall. A cylinder head closes in the top of the cylinder forming the combustion chamber which is sealed by a head gasket (head). The head provides space for air and fuel intake valves, exhaust valves, and mounts for spark plugs and fuel injectors.
Waste gases from combustion are removed from the combustion chamber by the:
camshaft |
|
head gasket |
|
piston |
|
exhaust valve |
The combustion chamber is located in the cylinder head and contains the combustion of the air-fuel mixture. This mixture is delivered by an intake valve and the waste gases from combustion are removed from the combustion chamber by the exhaust valve.
An overcooled engine:
uses less gasoline |
|
generates more power |
|
is more efficient |
|
is less efficient |
An overcooled engine is less efficient. During the power stroke, combustion heat pushes down the piston. If too much of this heat is lost to the cooling system, the fuel might not combust completely and contaminate the engine's lubricating oil diminishing its lubricating ability. Incomplete combustion of fuel also negatively affects the engine's fuel efficiency and power output.
Which of the following is not a common vehicle cylinder arrangement?
opposed |
|
inline |
|
V-type |
|
vertical |
Cylinder number and arrangement depends on the purpose of the engine. Smaller (four and six cylinder) engines in front-wheel drive vehicles often use an inline design which orients cylinders vertically over the crankshaft and aligns them in a row. Other common orientations are a horizontal/opposed design which places cylinders flat facing each other with the crankshaft between them and a V-type design common in six and eight cylinder engines that features one cylinder head per block of cylinders oriented at a 60 to 90 degree angle to each other with the crankshaft at the bottom of the V.
The distributor is responsible for:
utlizing battery power to start the engine |
|
timing the spark and distributing it to the correct cylinder |
|
distributing power to the correct drive wheels |
|
recharging the battery |
The distributor is driven by the engine's camshaft and is responsible for timing the spark and distributing it to the correct cylinder. The distributor cap contains a rotor that connects the ignition coil (and its high voltage) to the proper cylinder at the proper point in the stroke cycle.