ASVAB Automotive Information Practice Test 997005 Results

Your Results Global Average
Questions 5 5
Correct 0 3.08
Score 0% 62%

Review

1

Power brakes multiply the force a driver applies to the brake pedal using a __________ connected to the engine intake manifold.

54% Answer Correctly

cylinder

brake line

vacuum booster

speed sensor


Solution

Power brakes multiply the force a driver applies to the brake pedal using a vacuum booster connected to the engine intake manifold. This provides for much higher hydraulic pressure in the braking system than could be generated by the driver alone. Antilock brakes (ABS) use speed sensors and adjust the brake pressure at each wheel to prevent skidding and allow the driver more steering control in slippery conditions.


2

Which of these is not necessary for combustion?

80% Answer Correctly

heat source

fuel

accelerant

air


Solution

Combustion is the burning of an air-fuel mixture to provide energy. It requires the presence of air, fuel, and a heat source to ignite the air-fuel mixture. In the internal combustion engine that powers automobiles and trucks the combustion happens inside the engine utilzing a fuel like gasoline, diesel fuel, or natural gas.


3

Which of the following is the name for a transmission that incorporates the differential in one package?

57% Answer Correctly

four-wheel drive transmission

transaxle

automatic transmission

manual transmission


Solution

A differential is designed to drive a pair of wheels while allowing them to rotate at different speeds. A transaxle is a transmission that incorporates the differential in one package. Most front-wheel drive cars use a transaxle while rear-wheel drive cars use a transmission and separate differential connected via a drive shaft. The differential is incorporated into the drive axle which splits engine power delivered by the drive shaft between the two drive wheels. All-wheel drive cars typically use a transaxle that includes an output shaft to the rear differential.


4

The steering __________ transfers the motion of the steering gear output shaft to the steering arms that turn the wheels.

57% Answer Correctly

column

linkage

cylinder

arms


Solution

The steering linkage is a system of pivots and connecting parts between the steering gear and the control arms. The steering linkage transfers the motion of the steering gear output shaft to the steering arms that turn the wheels.


5

What's the name of the low-voltage winding in the ignition coil?

57% Answer Correctly

primary coil winding

distributor coil winding

tertiary coil winding

secondary coil winding


Solution

The ignition coil is a high-voltage transformer made up of two coils of wire. The primary coil winding is the low-voltage winding and has relatively few turns of heavy wire. The secondary coil winding is the high-voltage winding that surrounds the primary and is made up of thousands of turns of fine wire. Current flows from the battery through the primary coil winding which creates a changing magnetic field inside the secondary coil. This induces a very high-voltage current in the secondary coil which it feeds to the distributor.