A series circuit has only one path for current to flow. In a series circuit, current (I) is the same throughout the circuit and is equal to the total voltage (V) applied to the circuit divided by the total resistance (R) of the loads in the circuit. The sum of the voltage drops across each resistor in the circuit will equal the total voltage applied to the circuit.

Ohm's law specifies the relationship between voltage (V), current (I), and resistance (R) in an electrical circuit: V = IR.

Solved for current, I = \( \frac{V}{R} \) = \( \frac{450}{50} \) = 9 A

Lights connected in series form a chain with each light connecting to adjacent lights via one wire. Therefore, if one of the lights burns out and breaks the series, none of the other lights will receive power and they'll go dark. Lights connected in parallel each connect to the positive and negative nodes of the power source and would not go dark if one of their neighbors burnt out.

Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.

Voltage (V) is the electrical potential difference between two points. Electrons will flow as current from areas of high potential (concentration of electrons) to areas of low potential. Voltage and current are directly proportional in that the higher the voltage applied to a conductor the higher the current that will result.