ASVAB Electronics Information Practice Test 106933 Results

Your Results Global Average
Questions 5 5
Correct 0 3.29
Score 0% 66%

Review

1

The diameter of a number 12 wire is __________ the diameter of a number 6 wire?

52% Answer Correctly

less than

more than

triple

double


Solution

The larger the number the smaller the diameter of the wire. So, the diameter of a number 12 wire is less than the diameter of a number 6 wire.


2

Capacitors are charged by what type of current?

65% Answer Correctly

high voltage

direct

low voltage

alternating


Solution

Capacitors store voltage and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors are often used to maintain power within a system when it is disconnected from its primary power source or to smooth out or filter voltage within a circuit.


3

A transistor works by allowing a small amount of current to control general current flow. Where is the small amount of current applied?

55% Answer Correctly

input

emitter

base

collector


Solution

The transistor is the foundation of modern electronic devices. It is made entirely from semiconductor material (making it a solid state device) and can serve many different functions in a circuit including acting as a switch, amplifier, or current regulator. A transistor works by allowing a small amount of current applied at the base to control general current flow from collector to emitter through the transistor.


4 A circuit with a 120-volt power supply is protected by a 10-amp circuit breaker. What is the largest number of watts loads on this circuit can safely use?
85% Answer Correctly
400 W
1200 W
3600 W
1800 W

Solution
Wattage is current multiplied by voltage: W = IV. So, the maximum amount of power a 120-volt circuit with a 10A circuit breaker would allow is 120V x 10A = 1200 W.

5

This circuit component symbol represents a(n):

72% Answer Correctly

inductor

capacitor

resistor

potentiometer


Solution

Resistors are used to limit voltage and/or current in a circuit and can have a fixed or variable resistance.  Variable resistors (often called potentiometers or rheostats) are used when dynamic control over the voltage/current in a circuit is needed, for example, in a light dimmer or volume control.