ASVAB Electronics Information Practice Test 107814 Results

Your Results Global Average
Questions 5 5
Correct 0 3.17
Score 0% 63%

Review

1

Resistance is opposition to which of the following?

70% Answer Correctly

voltage

current

impedance

conductance


Solution

Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.


2

Which of the following is not a characteristic of direct current?

48% Answer Correctly

electrons flow in only one consistent direction

used to power your cell phone

an example power source is a generator

cannot easily travel distances without power loss


Solution

Direct current flows in only one direction in a circuit, from the negative terminal of the voltage source to the positive. A common source of DC is a battery. In contrast to the constant one-way flow of direct current, alternating current changes direction many times each second. Electricity is delivered from power stations to customers as AC because it provides a more efficient way to transport electricity over long distances.


3

What is the frequency of most household electrical systems?

60% Answer Correctly

110V

60Hz

60MHz

110Hz


Solution

Electricity is delivered from power stations to customers as AC because it provides a more efficient way to transport electricity over long distances. Most households use electricity with a frequency of 60Hz.


4

One of the lights on your Christmas tree burns out and this causes the rest of the lights connected to that strand to go dark. How are the lights in that strand connected?

74% Answer Correctly

series-parallel

perpendicular

series

parallel


Solution

Lights connected in series form a chain with each light connecting to adjacent lights via one wire. Therefore, if one of the lights burns out and breaks the series, none of the other lights will receive power and they'll go dark. Lights connected in parallel each connect to the positive and negative nodes of the power source and would not go dark if one of their neighbors burnt out.


5 How would you connect 6 [9V 20A] batteries to achieve a combined power output of 27V 60A?
66% Answer Correctly
orthogonal
series
parallel
series-parallel

Solution

Connecting the 6 batteries in series multiplies their voltage while keeping their current the same yielding a 54V 20A configuration. Connecting the 6 batteries in parallel multiplies their current while keeping their voltage the same yieleding a 9V 120A configuration. Using a series-parallel connection, 3 batteries can be connected in series and 3 can be connected in parallel resulting in a 27V 60A configuration.