ASVAB Electronics Information Practice Test 111615 Results

Your Results Global Average
Questions 5 5
Correct 0 3.42
Score 0% 68%

Review

1

An amplifier is most similar in function to which of the following:

65% Answer Correctly

capacitor

step-down transformer

transistor

step-up transformer


Solution

An amplifier is a device that takes a small input signal and creates a larger output signal. This makes it most similar to a step-up transformer which takes a smaller input voltage and creates a larger output voltage.


2

One of the lights on your Christmas tree burns out and this causes the rest of the lights connected to that strand to go dark. How are the lights in that strand connected?

74% Answer Correctly

series-parallel

parallel

perpendicular

series


Solution

Lights connected in series form a chain with each light connecting to adjacent lights via one wire. Therefore, if one of the lights burns out and breaks the series, none of the other lights will receive power and they'll go dark. Lights connected in parallel each connect to the positive and negative nodes of the power source and would not go dark if one of their neighbors burnt out.


3

This circuit component symbol represents a(n):

67% Answer Correctly

transistor

diode

inductor

transformer


Solution

The transistor is the foundation of modern electronic devices. It is made entirely from semiconductor material (making it a solid state device) and can serve many different functions in a circuit including acting as a switch, amplifier, or current regulator. A transistor works by allowing a small amount of current applied at the base to control general current flow from collector to emitter through the transistor.


4

The joule is a unit of measurement for:

67% Answer Correctly

energy

capacitance

resistance

power


Solution

The joule is a unit of measurement for energy.


5

This circuit component symbol represents a(n):

70% Answer Correctly

resistor

diode

capacitor

fuse


Solution

Fuses are thin wires that melt when the current in a circuit exceeds a preset amount. They help prevent short circuits from damaging circuit components when an unusually large current is applied to the circuit, either through component failure or spikes in applied voltage.