A thermocouple is a temperature sensor that consists of two wires made from different conductors. The junction of these two wires produces a voltage based on the temperature difference between them and can be used like a switch to open or close the circuit at a designated temperature.

Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.

Direct current flows in only one direction in a circuit, from the negative terminal of the voltage source to the positive. A common source of DC is a battery. In contrast to the constant one-way flow of direct current, alternating current changes direction many times each second. Electricity is delivered from power stations to customers as AC because it provides a more efficient way to transport electricity over long distances.

As their names indicate, a step-up transformer is used to step up or increase voltage and a step-down transformer is used to step down or decrease voltage. In a step-up transformer, the secondary voltage is higher than the primary voltage and it has more turns in the secondary winding than in the primary winding.

The transistor is the foundation of modern electronic devices. It is made entirely from semiconductor material (making it a solid state device) and can serve many different functions in a circuit including acting as a switch, amplifier, or current regulator. A transistor works by allowing a small amount of current applied at the base to control general current flow from collector to emitter through the transistor.