ASVAB Electronics Information Practice Test 186493 Results

Your Results Global Average
Questions 5 5
Correct 0 3.21
Score 0% 64%

Review

1

The rate of flow of electrons per unit time is which of the following?

74% Answer Correctly

voltage

resistance

current

conductance


Solution

Current is the rate of flow of electrons per unit time and is measured in amperes (A). A coulomb (C) is the quantity of electricity conveyed in one second by a current of one ampere.


2

In an electrical circuit, resistors have fixed or __________ resistance.

69% Answer Correctly

series

variable

parallel

dynamic


Solution

Resistors are used to limit voltage and/or current in a circuit and can have a fixed or variable resistance.  Variable resistors (often called potentiometers or rheostats) are used when dynamic control over the voltage/current in a circuit is needed, for example, in a light dimmer or volume control.


3

Which of the following is not a common type of battery?

41% Answer Correctly

dry cell

power-cycle

wet cell

deep-cycle


Solution

Direct current flows in only one direction in a circuit, from the negative terminal of the voltage source to the positive. A common source of direct current (DC) is a battery. The three most common types of batteries are dry cell (used in small devices like TV remotes), wet cell (used for cars), and deep-cycle (storage batteries used primarily for backup and emergency power).


4

A solid state device has which of the following characteristics?

53% Answer Correctly

made entirely from semiconductor material

made entirely from insulative material

made from a mix of conductive and insulative material

made entirely from conductive material


Solution

The transistor is the foundation of modern electronic devices. It is made entirely from semiconductor material (making it a solid state device) and can serve many different functions in a circuit including acting as a switch, amplifier, or current regulator. A transistor works by allowing a small amount of current applied at the base to control general current flow from collector to emitter through the transistor.


5 A circuit with a 120-volt power supply is protected by a 5-amp circuit breaker. What is the largest number of watts loads on this circuit can safely use?
82% Answer Correctly
540 W
660 W
600 W
602 W

Solution
Wattage is current multiplied by voltage: W = IV. So, the maximum amount of power a 120-volt circuit with a 5A circuit breaker would allow is 120V x 5A = 600 W.