ASVAB Electronics Information Practice Test 190623 Results

Your Results Global Average
Questions 5 5
Correct 0 2.92
Score 0% 58%

Review

1

Current is the rate of flow of electrons per unit time and is measured in:

69% Answer Correctly

coulombs

volts

ohms

amperes


Solution

Current is the rate of flow of electrons per unit time and is measured in amperes (A). A coulomb (C) is the quantity of electricity conveyed in one second by a current of one ampere.


2

Which of the following is not true about a line drop?

43% Answer Correctly

it is a decrease in voltage between two points on a line

it is addressed by raising current and lowering voltage across the ransmission line

it is addressed by raising voltage and lowering current across the transmission line

it is caused by resistance


Solution

Electricity is delivered from power stations to customers as AC because it provides a more efficient way to transport electricity over long distances. A line drop is a decrease in voltage between two points on an electrical transmission line due to resistance in the line. A lower current and higher voltage across the line will help compensate for the line drop.


3

Capacitors are charged by what type of current?

64% Answer Correctly

high voltage

low voltage

alternating

direct


Solution

Capacitors store voltage and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors are often used to maintain power within a system when it is disconnected from its primary power source or to smooth out or filter voltage within a circuit.


4

A transistor works by allowing a small amount of current to control general current flow. Where is the small amount of current applied?

55% Answer Correctly

collector

input

emitter

base


Solution

The transistor is the foundation of modern electronic devices. It is made entirely from semiconductor material (making it a solid state device) and can serve many different functions in a circuit including acting as a switch, amplifier, or current regulator. A transistor works by allowing a small amount of current applied at the base to control general current flow from collector to emitter through the transistor.


5

In a series circuit, which of the following is the same across all branches of the circuit?

60% Answer Correctly

voltage

resistance

current

conductance


Solution

A series circuit has only one path for current to flow. In a series circuit, current (I) is the same throughout the circuit and is equal to the total voltage (V) applied to the circuit divided by the total resistance (R) of the loads in the circuit. The sum of the voltage drops across each resistor in the circuit will equal the total voltage applied to the circuit.