ASVAB Electronics Information Practice Test 202688 Results

Your Results Global Average
Questions 5 5
Correct 0 3.28
Score 0% 66%

Review

1

The formula specifying Ohm's law is which of the following?

76% Answer Correctly

\(V = {I \over R}\)

V = IR

\(V = {R \over I}\)

V = I2R


Solution

Ohm's law specifies the relationship between voltage (V), current (I), and resistance (R) in an electrical circuit: V = IR.


2

This circuit component symbol represents a(n):

60% Answer Correctly

capacitor

transformer

resistor

inductor


Solution

An inductor is coiled wire that stores electric energy in the form of magnetic energy and resists changes in the electric current flowing through it. If current is increasing, the inductor produces a voltage that slows the increase and, if current is decreasing, the magnetic energy in the coil opposes the decrease to keep the current flowing longer. In contrast to capacitors, inductors allow DC to pass easily but resist the flow of AC.


3

The sum of the voltage drops across each resistor in a __________ circuit will equal the total voltage applied to the circuit.

54% Answer Correctly

series-parallel

series

closed

parallel


Solution

A series circuit has only one path for current to flow. In a series circuit, current (I) is the same throughout the circuit and is equal to the total voltage (V) applied to the circuit divided by the total resistance (R) of the loads in the circuit. The sum of the voltage drops across each resistor in the circuit will equal the total voltage applied to the circuit.


4

The conversion of alternating current (AC) into direct current (DC) is called:

69% Answer Correctly

inductance

capacitance

rectification

reactance


Solution

A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.


5

In an electrical circuit, resistors have fixed or __________ resistance.

69% Answer Correctly

parallel

variable

series

dynamic


Solution

Resistors are used to limit voltage and/or current in a circuit and can have a fixed or variable resistance.  Variable resistors (often called potentiometers or rheostats) are used when dynamic control over the voltage/current in a circuit is needed, for example, in a light dimmer or volume control.