| Your Results | Global Average | |
|---|---|---|
| Questions | 5 | 5 |
| Correct | 0 | 2.90 |
| Score | 0% | 58% |
This circuit component symbol represents a(n):
capacitor |
|
inductor |
|
diode |
|
transistor |
A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.
A solid state device has which of the following characteristics?
made entirely from semiconductor material |
|
made entirely from insulative material |
|
made entirely from conductive material |
|
made from a mix of conductive and insulative material |
The transistor is the foundation of modern electronic devices. It is made entirely from semiconductor material (making it a solid state device) and can serve many different functions in a circuit including acting as a switch, amplifier, or current regulator. A transistor works by allowing a small amount of current applied at the base to control general current flow from collector to emitter through the transistor.
What kind of diode allows current to flow in the opposite direction once a certain voltage threshold is reached?
v-type diode |
|
light emitting diode |
|
zener diode |
|
standard diode |
A diode allows current to pass easily in one direction and blocks current in the other direction. A zener diode is a diode which allows current to flow in one direction as normal and will also allow current flow in the reverse direction when the voltage is above a certain value. This value is called the breakdown voltage.
The farad is a unit of measurement for:
inductance |
|
capacitance |
|
energy |
|
power |
Capacitors store electricity and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors are often used to maintain power within a system when it is disconnected from its primary power source or to smooth out or filter voltage within a circuit.
| parallel | |
| series-parallel | |
| series | |
| perpendicular |
Connecting the 4 batteries in series multiplies their voltage while keeping their current the same yielding a 24V 10A configuration. Connecting the 4 batteries in parallel multiplies their current while keeping their voltage the same yieleding a 6V 40A configuration. Using a series-parallel connection, 2 batteries can be connected in series and 2 can be connected in parallel resulting in a 12V 20A configuration.