ASVAB Electronics Information Practice Test 213724 Results

Your Results Global Average
Questions 5 5
Correct 0 3.53
Score 0% 71%

Review

1

What is the primary difference between a rectifier and an inverter?

61% Answer Correctly

a rectifier strips out the DC portion of electricity while an inverter strips out the AC portion

a rectifier converts an AC input to DC while an inverter converts a DC input to AC

a rectifier strips out the AC portion of electricity while an inverter strips out the DC portion

a rectifier converts a DC input to AC while an inverter converts an AC input to DC


Solution

A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.


2

Which of the following is not a purpose of a resistor in an electrical circuit?

70% Answer Correctly

limit the current in the circuit

moderate the heat in the circuit

control the voltage in the circuit

multiply the current in the circuit


Solution

Resistors can be chosen in a wide variety of values to control the voltage in a circuit, limit the current, or moderate the heat produced by the components in the circuit.


3 What's the overall power consumption of a piece of equipment that is rated for 4 amps at 80 volts?
80% Answer Correctly
321.5 W
480 W
320 W
160 W

Solution
Power is measured in watts (W) and 1 watt equals 1 ampere multiplied by 1 volt: P = \( V \times I \). For this problem, the equipment is rated for 4 amps (I) at 80 volts (V) so the equation becomes P = \( 80 \times 4 \) = 320 W

4

The ampere is a unit of measurement for:

79% Answer Correctly

power

inductance

current

energy


Solution

Current is the rate of flow of electrons per unit time and is measured in amperes (A). A coulomb (C) is the quantity of electricity conveyed in one second by a current of one ampere.


5

The valence shell of n insulator is how full of electrons?

56% Answer Correctly

empty

more than half full

half full

less than half full


Solution

Insulators have valence shells that are more than half full of electrons and, as such, are tightly bound to the nucleus and difficult to move from one atom to another.