ASVAB Electronics Information Practice Test 215270 Results

Your Results Global Average
Questions 5 5
Correct 0 3.06
Score 0% 61%

Review

1

The conversion of alternating current (AC) into direct current (DC) is called:

69% Answer Correctly

capacitance

inductance

reactance

rectification


Solution

A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.


2

Which of the following converts electrical energy into another form of energy in an electrical circuit?

61% Answer Correctly

wiring

DC source

load

AC source


Solution

A load is a source of resistance that converts electrical energy into another form of energy. The components of a microwave, for example, are loads that work together to convert household electricity into radation that can be used to quickly cook food.


3

Electromotive force is another name for:

53% Answer Correctly

voltage

energy

current

power


Solution

Voltage (V) is the electrical potential difference between two points. Electrons will flow as current from areas of high potential (concentration of electrons) to areas of low potential. Voltage and current are directly proportional in that the higher the voltage applied to a conductor the higher the current that will result.


4

Which of the following will increase the magnetic field produced by the electric current in a wire?

68% Answer Correctly

wind the wire into a coil

construct the wire from conductive material

construct the wire from insulative material

wrap the wire around a ceramic core


Solution

A moving electric current produces a magnetic field proportional to the amount of current flow. This magnetic field can be made stronger by winding the wire into a coil and further enhanced if done around an iron containing (ferrous) core.


5

The voltage output of a transformer primarily depends on which of the following?

57% Answer Correctly

the diameter of the coils

the diameter of the wire in the coils

the number of turns in the wire of the coils

the conductor used for the wire in the coils


Solution

A transformer utilizes an inductor to increase or decrease the voltage in a circuit. AC flowing in a coil wrapped around an iron core magnetizes the core causing it to produce a magnetic field. This magnetic field generates a voltage in a nearby coil of wire and, depending on the number of turns in the wire of the primary (source) and secondary coils and their proximity, voltage is induced in the secondary coil.