ASVAB Electronics Information Practice Test 24458 Results

Your Results Global Average
Questions 5 5
Correct 0 3.39
Score 0% 68%

Review

1

Which of the following will increase the magnetic field produced by the electric current in a wire?

68% Answer Correctly

wrap the wire around a ceramic core

construct the wire from conductive material

wind the wire into a coil

construct the wire from insulative material


Solution

A moving electric current produces a magnetic field proportional to the amount of current flow. This magnetic field can be made stronger by winding the wire into a coil and further enhanced if done around an iron containing (ferrous) core.


2

The sum of the voltage drops across each resistor in a __________ circuit will equal the total voltage applied to the circuit.

54% Answer Correctly

series

series-parallel

closed

parallel


Solution

A series circuit has only one path for current to flow. In a series circuit, current (I) is the same throughout the circuit and is equal to the total voltage (V) applied to the circuit divided by the total resistance (R) of the loads in the circuit. The sum of the voltage drops across each resistor in the circuit will equal the total voltage applied to the circuit.


3

From what energy do photovoltaic cells produce electrical energy?

68% Answer Correctly

magnetic

sun

nuclear

chemical


Solution

A photovoltaic cell (also known as a solar cell) converts energy from the sun into electrical energy.


4

Current is the rate of flow of electrons per unit time and is measured in:

69% Answer Correctly

coulombs

ohms

amperes

volts


Solution

Current is the rate of flow of electrons per unit time and is measured in amperes (A). A coulomb (C) is the quantity of electricity conveyed in one second by a current of one ampere.


5

The volt is a unit of measurement for:

80% Answer Correctly

capacitance

current

power

voltage


Solution

Voltage (V) is the electrical potential difference between two points. Electrons will flow as current from areas of high potential (concentration of electrons) to areas of low potential. Voltage and current are directly proportional in that the higher the voltage applied to a conductor the higher the current that will result.