ASVAB Electronics Information Practice Test 245979 Results

Your Results Global Average
Questions 5 5
Correct 0 3.31
Score 0% 66%

Review

1

Which of the following is the preferred method for splicing wires?

56% Answer Correctly

screw-on connectors

wrap in small gauge wire

soldering

wire crimps


Solution

Splicing is permanently joining two wires together. Splicing can be done with screw-on connectors or wire crimps but the preferred method for splicing is soldering. Soldering takes the most effort but results in a connection that is electrically and mechanically identical to the original wire.


2

This circuit component symbol represents a(n):

67% Answer Correctly

inductor

diode

transistor

transformer


Solution

The transistor is the foundation of modern electronic devices. It is made entirely from semiconductor material (making it a solid state device) and can serve many different functions in a circuit including acting as a switch, amplifier, or current regulator. A transistor works by allowing a small amount of current applied at the base to control general current flow from collector to emitter through the transistor.


3

The watt is a unit of measurement for:

78% Answer Correctly

frequency

energy

resistance

power


Solution

Electrical power is measured in watts (W) and is calculated by multiplying the voltage (V) applied to a circuit by the resulting current (I) that flows in the circuit: P = IV. In addition to measuring production capacity, power also measures the rate of energy consumption and many loads are rated for their consumption capacity. For example, a 60W lightbulb utilizes 60W of energy to produce the equivalent of 60W of heat and light energy.


4

What is the primary difference between a rectifier and an inverter?

61% Answer Correctly

a rectifier converts an AC input to DC while an inverter converts a DC input to AC

a rectifier converts a DC input to AC while an inverter converts an AC input to DC

a rectifier strips out the DC portion of electricity while an inverter strips out the AC portion

a rectifier strips out the AC portion of electricity while an inverter strips out the DC portion


Solution

A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.


5

From what energy do photovoltaic cells produce electrical energy?

68% Answer Correctly

sun

nuclear

chemical

magnetic


Solution

A photovoltaic cell (also known as a solar cell) converts energy from the sun into electrical energy.