Insulators have valence shells that are more than half full of electrons and, as such, are tightly bound to the nucleus and difficult to move from one atom to another.

Circuits are not limited to only series or only parallel configurations. Most circuits contain a mix of series and parallel segments. A good example is a household circuit breaker. Electrical outlets in each section of the house are wired in parallel with the circuit breaker for that section wired in series making it easy to cut off electricity to the parallel parts of the circuit when needed.

Lights connected in series form a chain with each light connecting to adjacent lights via one wire. Therefore, if one of the lights burns out and breaks the series, none of the other lights will receive power and they'll go dark. Lights connected in parallel each connect to the positive and negative nodes of the power source and would not go dark if one of their neighbors burnt out.

Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.

Current in an electric circuit creates heat when the current overcomes resistance in the wire.