ASVAB Electronics Information Practice Test 275050 Results

Your Results Global Average
Questions 5 5
Correct 0 3.35
Score 0% 67%

Review

1

Why is an insulator a poor conductor of electricity?

68% Answer Correctly

an insulator has few free electrons

an insulator is made of organic material

an insulator is made of inorganic material

an insulator has many free electrons


Solution

Insulators have valence shells that are more than half full of electrons and, as such, are tightly bound to the nucleus and difficult to move from one atom to another.


2

The valence shell of a semiconductor is how full of electrons?

67% Answer Correctly

more than half full

less than half full

half full

empty


Solution

Semiconductors have valence shells that are exacly half full and can conduct electricity under some conditions but not others. This property makes them useful for the control of electrical current.


3

In metals, increasing the temperature typically _____________ conductivity.

50% Answer Correctly

eliminates

increases

does nothing to

decreases


Solution

All conductors have resistance and the amount of resistance varies with the element. Metals exhibit increased resistance (and, therefore, lower conductivity) as their temperature increases.


4 A circuit with a 120-volt power supply is protected by a 10-amp circuit breaker. What is the largest number of watts loads on this circuit can safely use?
82% Answer Correctly
1200 W
600 W
1080 W
1201.5 W

Solution
Wattage is current multiplied by voltage: W = IV. So, the maximum amount of power a 120-volt circuit with a 10A circuit breaker would allow is 120V x 10A = 1200 W.

5

Which of the following allows current to pass easily in one direction and blocks current in the other direction?

69% Answer Correctly

resistor

inductor

capacitor

diode


Solution

A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.