Electrons flow from an area of high concentration to an area of low concentration. A high voltage indicates a high concentration of electrons that creates a greater potential for electron flow than a low voltage. When applied to a load, voltage creates electricity and potential difference is the measure of voltage at a specific location in an electrical circuit.

Fuses are thin wires that melt when the current in a circuit exceeds a preset amount. They help prevent short circuits from damaging circuit components when an unusually large current is applied to the circuit, either through component failure or spikes in applied voltage.

In a parallel circuit, each load occupies a separate parallel path in the circuit and the input voltage is fully applied to each path. Unlike a series circuit where current (I) is the same at all points in the circuit, in a parallel circuit, voltage (V) is the same across each parallel branch of the circuit but current differs in each branch depending on the load (resistance) present.

All conductors have resistance and the amount of resistance varies with the element. Metals exhibit increased resistance (and, therefore, lower conductivity) as their temperature increases.

A series circuit has only one path for current to flow. In a series circuit, current (I) is the same throughout the circuit and is equal to the total voltage (V) applied to the circuit divided by the total resistance (R) of the loads in the circuit. The sum of the voltage drops across each resistor in the circuit will equal the total voltage applied to the circuit.