| Your Results | Global Average | |
|---|---|---|
| Questions | 5 | 5 |
| Correct | 0 | 3.33 |
| Score | 0% | 67% |
You would measure the amount of current through a circuit with a(n):
voltmeter |
|
battery |
|
potentiometer |
|
ammeter |
Current is the rate of flow of electrons per unit time and is measured in amperes (A). An ammeter is used to measure the electric current in a circuit.
In a series circuit, which of the following is the same across all branches of the circuit?
voltage |
|
resistance |
|
conductance |
|
current |
A series circuit has only one path for current to flow. In a series circuit, current (I) is the same throughout the circuit and is equal to the total voltage (V) applied to the circuit divided by the total resistance (R) of the loads in the circuit. The sum of the voltage drops across each resistor in the circuit will equal the total voltage applied to the circuit.
Silver and gold are among the most highly conductive elements. Why is copper used much more often as a conductor in electrical circuits?
silver and gold are brittle |
|
silver and gold are costly |
|
all of these |
|
copper is durable and relatively cheap |
All conductors have resistance and the amount of resistance varies with the element. But, resistance isn't the only consideration when choosing a conductor as the most highly conductive elements like silver and gold are also more expensive and more brittle than slightly less conductive elements like copper. A balance needs to be struck between the electrical qualities of a material and its cost and durability.
A transistor to an electronic circuit is like a _______________ to a house?
driveway |
|
safe |
|
no trespassing sign |
|
gate |
A transistor works by allowing a small amount of current applied at the base to control general current flow from collector to emitter through the transistor. A transistor acts as a gate or switch for electronic signals.
Which of the following is the same for each branch of a parallel circuit?
voltage |
|
power |
|
resistance |
|
current |
In a parallel circuit, each load occupies a separate parallel path in the circuit and the input voltage is fully applied to each path. Unlike a series circuit where current (I) is the same at all points in the circuit, in a parallel circuit, voltage (V) is the same across each parallel branch of the circuit but current differs in each branch depending on the load (resistance) present.