ASVAB Electronics Information Practice Test 281117 Results

Your Results Global Average
Questions 5 5
Correct 0 3.53
Score 0% 71%

Review

1

The conversion of alternating current (AC) into direct current (DC) is called:

69% Answer Correctly

inductance

reactance

capacitance

rectification


Solution

A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.


2

Which of the following is a difference between a circuit breaker and a fuse?

80% Answer Correctly

all of these

a circuit breaker can be reused

a fuse responds more quickly than a circuit breaker

a fuse is cheaper than a circuit breaker


Solution

Like fuses, circuit breakers stop current flow once it reaches a certain amount. They have the advantage of being reusable (fuses must be replaced when "blown") but respond more slowly to current surges and are more expensive than fuses.


3

Capacitors are charged by what type of current?

64% Answer Correctly

high voltage

alternating

direct

low voltage


Solution

Capacitors store voltage and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors are often used to maintain power within a system when it is disconnected from its primary power source or to smooth out or filter voltage within a circuit.


4

A __________ electric current produces a magnetic field proportional to the amount of current flow.

61% Answer Correctly

moving

low voltage

high voltage

stationary


Solution

A moving electric current produces a magnetic field proportional to the amount of current flow. This magnetic field can be made stronger by winding the wire into a coil and further enhanced if done around an iron containing (ferrous) core.


5

Which of these materials is not a good conductor of electricity?

79% Answer Correctly

gold

copper

tin

air


Solution

All conductors have resistance and the amount of resistance varies with the element. In general, metals make the best conductors of electricity and non-metals make the worst conductors of electricity.