ASVAB Electronics Information Practice Test 28591 Results

Your Results Global Average
Questions 5 5
Correct 0 2.91
Score 0% 58%

Review

1

Inductance is a factor in which of the following?

44% Answer Correctly

a DC circuit

determining energy stored by a capacitor

an AC circuit

batteries connected in serial


Solution

Inductance is a property of an AC circuit (or a component in an AC circuit) that quantifies resistance to changes in current. The current in an AC circuit is continuously changing and inductive reactance (the opposition to change) depends both on the inductance of the circuit or component and the rate at which the current is changing.


2

Direct current flows from the __________ terminal of the voltage source to the __________ terminal.

62% Answer Correctly

negative, positive

positive, negative

negative, negative

positive, positive


Solution

Direct current flows in only one direction in a circuit, from the negative terminal of the voltage source to the positive. A common source of direct current (DC) is a battery.


3

Which of the following allows DC to pass easily but resists the flow of AC?

55% Answer Correctly

transformer

semiconductor

capacitor

inductor


Solution

An inductor is coiled wire that stores electric energy in the form of magnetic energy and resists changes in the electric current flowing through it. If current is increasing, the inductor produces a voltage that slows the increase and, if current is decreasing, the magnetic energy in the coil opposes the decrease to keep the current flowing longer. In contrast to capacitors, inductors allow DC to pass easily but resist the flow of AC.


4

Capacitors connected in series produce __________ capacitance compared to capacitors connected in parallel.

45% Answer Correctly

no

more

the same

less


Solution

Capacitors store electricity and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors connected in series produce less capacitance than capacitors connected in parallel.


5

You would measure the amount of voltage between two points in a circuit with a(n):

83% Answer Correctly

battery

voltmeter

reostat

ammeter


Solution

Voltage (V) is the electrical potential difference between two points. A voltmeter is used to measure the voltage between two points in a circuit.