ASVAB Electronics Information Practice Test 291592 Results

Your Results Global Average
Questions 5 5
Correct 0 3.58
Score 0% 72%

Review

1

Which of the following statements about electrical resistance is true?

75% Answer Correctly

the less resistive the conductor is the slower electron flow will be

the more resistive the conductor is the faster electron flow will be

the more resistive the conductor is the slower electron flow will be

electrically conductive materials have no resistive properties


Solution

Resistance is opposition to the flow of current. As resistance increases, current decreases as resistance and current are inversely proportional.


2

Why does current in an electric circuit create heat?

77% Answer Correctly

the wire in the circuit burns when current passes through

voltage is naturally hot

current is naturally hot

heat is created when the current overcomes resistance in the wire


Solution

Current in an electric circuit creates heat when the current overcomes resistance in the wire.


3

Resistance is measured in:

86% Answer Correctly

ohms

coulombs

amperes

volts


Solution

Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.


4

What is the voltage of most household electrical systems in the United States?

59% Answer Correctly

60Hz

220V

60V

110V


Solution

Most households use electricity with a voltage of 110V.


5

In a series circuit, which of the following is the same across all branches of the circuit?

61% Answer Correctly

voltage

resistance

conductance

current


Solution

A series circuit has only one path for current to flow. In a series circuit, current (I) is the same throughout the circuit and is equal to the total voltage (V) applied to the circuit divided by the total resistance (R) of the loads in the circuit. The sum of the voltage drops across each resistor in the circuit will equal the total voltage applied to the circuit.