| Your Results | Global Average | |
|---|---|---|
| Questions | 5 | 5 |
| Correct | 0 | 2.87 |
| Score | 0% | 57% |
In an electronic circuit, a thermocouple can be used to:
link the temperature of one component in the circuit to that of another component in the circuit |
|
open or close a circuit at a designated temperature |
|
increase or decrease the temperature of a component in the circuit |
|
keep the circuit at a designated safe temperature |
A thermocouple is a temperature sensor that consists of two wires made from different conductors. The junction of these two wires produces a voltage based on the temperature difference between them and can be used like a switch to open or close the circuit at a designated temperature.
Which of the following statements about electrical resistance is true?
the more resistive the conductor is the faster electron flow will be |
|
electrically conductive materials have no resistive properties |
|
the less resistive the conductor is the slower electron flow will be |
|
the more resistive the conductor is the slower electron flow will be |
Resistance is opposition to the flow of current. As resistance increases, current decreases as resistance and current are inversely proportional.
Which of the following is not a common type of battery?
power-cycle |
|
wet cell |
|
deep-cycle |
|
dry cell |
Direct current flows in only one direction in a circuit, from the negative terminal of the voltage source to the positive. A common source of direct current (DC) is a battery. The three most common types of batteries are dry cell (used in small devices like TV remotes), wet cell (used for cars), and deep-cycle (storage batteries used primarily for backup and emergency power).
The electrical potential difference between two points is called:
voltage |
|
resistance |
|
current |
|
conductance |
Voltage (V) is the electrical potential difference between two points. Electrons will flow as current from areas of high potential (concentration of electrons) to areas of low potential. Voltage and current are directly proportional in that the higher the voltage applied to a conductor the higher the current that will result.
This circuit component symbol represents a(n):
diode |
|
resistor |
|
capacitor |
|
fuse |
Fuses are thin wires that melt when the current in a circuit exceeds a preset amount. They help prevent short circuits from damaging circuit components when an unusually large current is applied to the circuit, either through component failure or spikes in applied voltage.