A load is a source of resistance that converts electrical energy into another form of energy. The components of a microwave, for example, are loads that work together to convert household electricity into radation that can be used to quickly cook food.

A semiconductor is a material that has a limited ability to conduct electrical current with conductivity between that of an insulator and that of a conductor. Silicon, a cheap and abundant material, is the most used semiconductor material although other materials are used in the electronics components made from semiconductors. The primary advantages of a semiconductor over a conductor is that the conductivity of a semiconductor can be varied under an external electrical field giving engineers precise control over complex circuits and, unlike conductors like metals, a semiconductor's conductivity increases with increased temperatures.

A series circuit has only one path for current to flow. In a series circuit, current (I) is the same throughout the circuit and is equal to the total voltage (V) applied to the circuit divided by the total resistance (R) of the loads in the circuit. The sum of the voltage drops across each resistor in the circuit will equal the total voltage applied to the circuit.

Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.

Splicing is permanently joining two wires together. Splicing can be done with screw-on connectors or wire crimps but the preferred method for splicing is soldering. Soldering takes the most effort but results in a connection that is electrically and mechanically identical to the original wire.