Circuits are not limited to only series or only parallel configurations. Most circuits contain a mix of series and parallel segments. A good example is a household circuit breaker. Electrical outlets in each section of the house are wired in parallel with the circuit breaker for that section wired in series making it easy to cut off electricity to the parallel parts of the circuit when needed.

A series circuit has only one path for current to flow. In a series circuit, current (I) is the same throughout the circuit and is equal to the total voltage (V) applied to the circuit divided by the total resistance (R) of the loads in the circuit. The sum of the voltage drops across each resistor in the circuit will equal the total voltage applied to the circuit.

Direct current flows in only one direction in a circuit, from the negative terminal of the voltage source to the positive. A common source of direct current (DC) is a battery.

A transistor works by allowing a small amount of current applied at the base to control general current flow from collector to emitter through the transistor. A transistor acts as a gate or switch for electronic signals.

You can multiply the voltage or the current supplied by individual batteries by connecting them together either in series or in parallel. The characteristics of batteries connected in parallel are that total voltage equals the average of the individual battery voltages, total current equals the sum of the individual battery currents, the positive terminal of one battery is connected to the positive terminal of the next, the negative terminal of one battery is connected to the negative terminal of the next, and two connections are made between each adjacent battery.