ASVAB Electronics Information Practice Test 320211 Results

Your Results Global Average
Questions 5 5
Correct 0 3.38
Score 0% 68%

Review

1

Capacitors are charged by what type of current?

64% Answer Correctly

low voltage

high voltage

direct

alternating


Solution

Capacitors store voltage and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors are often used to maintain power within a system when it is disconnected from its primary power source or to smooth out or filter voltage within a circuit.


2

Which of these materials is not a good conductor of electricity?

79% Answer Correctly

tin

air

gold

copper


Solution

All conductors have resistance and the amount of resistance varies with the element. In general, metals make the best conductors of electricity and non-metals make the worst conductors of electricity.


3

This circuit component symbol represents a(n):

70% Answer Correctly

diode

resistor

capacitor

fuse


Solution

Fuses are thin wires that melt when the current in a circuit exceeds a preset amount. They help prevent short circuits from damaging circuit components when an unusually large current is applied to the circuit, either through component failure or spikes in applied voltage.


4

This circuit component symbol represents a(n):

55% Answer Correctly

potentiometer

inductor

fuse

transformer


Solution

Resistors are used to limit voltage and/or current in a circuit and can have a fixed or variable resistance.  Variable resistors (often called potentiometers or rheostats) are used when dynamic control over the voltage/current in a circuit is needed, for example, in a light dimmer or volume control.


5

Resistance and current are __________ proportional.

68% Answer Correctly

not

exponentially

directly

inversely


Solution

Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.