ASVAB Electronics Information Practice Test 334105 Results

Your Results Global Average
Questions 5 5
Correct 0 3.59
Score 0% 72%

Review

1

Resistance is measured in:

86% Answer Correctly

ohms

amperes

coulombs

volts


Solution

Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.


2

Electricity cannot flow...

72% Answer Correctly

through an open circuit

through a closed circuit

through a circuit with resistance

through a circuit under load


Solution

An electrical circuit is a path through which electricity flows. This path contains one or more components that create a load (something that is using electricity) and that load acts as resistance to the passage of electricity through the circuit. Electricity can only flow through a circuit when the path is closed and cannot flow through an open circuit.


3

In household electrical wiring, which color of insulation indicates the 'hot' wire?

50% Answer Correctly

white

black

red

green


Solution

In the NM cable used for wiring homes, each cable has three wires inside a sheath with each wire covered in a different color of insulation to indicate its type. The wire with the black insulation is the 'hot' wire, white is the neutral wire, and the ground wire is either covered in green insulation or left bare.


4 A circuit with a 120-volt power supply is protected by a 10-amp circuit breaker. What is the largest number of watts loads on this circuit can safely use?
84% Answer Correctly
2400 W
1200 W
1320 W
3600 W

Solution
Wattage is current multiplied by voltage: W = IV. So, the maximum amount of power a 120-volt circuit with a 10A circuit breaker would allow is 120V x 10A = 1200 W.

5

An amplifier is most similar in function to which of the following:

65% Answer Correctly

capacitor

transistor

step-down transformer

step-up transformer


Solution

An amplifier is a device that takes a small input signal and creates a larger output signal. This makes it most similar to a step-up transformer which takes a smaller input voltage and creates a larger output voltage.