ASVAB Electronics Information Practice Test 342402 Results

Your Results Global Average
Questions 5 5
Correct 0 3.72
Score 0% 74%

Review

1

This circuit component symbol represents a(n):

65% Answer Correctly

fuse

diode

potentiometer

capacitor


Solution

Capacitors store electricity and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors are often used to maintain power within a system when it is disconnected from its primary power source or to smooth out or filter voltage within a circuit.


2

Which of the following statements about electrical resistance is true?

75% Answer Correctly

the less resistive the conductor is the slower electron flow will be

electrically conductive materials have no resistive properties

the more resistive the conductor is the faster electron flow will be

the more resistive the conductor is the slower electron flow will be


Solution

Resistance is opposition to the flow of current. As resistance increases, current decreases as resistance and current are inversely proportional.


3

Resistance is opposition to which of the following?

70% Answer Correctly

impedance

voltage

conductance

current


Solution

Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.


4

Which of the following is a difference between a circuit breaker and a fuse?

80% Answer Correctly

a circuit breaker can be reused

all of these

a fuse responds more quickly than a circuit breaker

a fuse is cheaper than a circuit breaker


Solution

Like fuses, circuit breakers stop current flow once it reaches a certain amount. They have the advantage of being reusable (fuses must be replaced when "blown") but respond more slowly to current surges and are more expensive than fuses.


5 A circuit with a 120-volt power supply is protected by a 10-amp circuit breaker. What is the largest number of watts loads on this circuit can safely use?
82% Answer Correctly
2400 W
1200 W
1320 W
3600 W

Solution
Wattage is current multiplied by voltage: W = IV. So, the maximum amount of power a 120-volt circuit with a 10A circuit breaker would allow is 120V x 10A = 1200 W.