ASVAB Electronics Information Practice Test 351555 Results

Your Results Global Average
Questions 5 5
Correct 0 3.32
Score 0% 66%

Review

1

Which of the following is the formula for calculating electrical power?

73% Answer Correctly

P = IV

\(P = {V \over I}\)

\(P = {I \over V}\)

P = I2V


Solution

Electrical power is measured in watts (W) and is calculated by multiplying the voltage (V) applied to a circuit by the resulting current (I) that flows in the circuit: P = IV. In addition to measuring production capacity, power also measures the rate of energy consumption and many loads are rated for their consumption capacity. For example, a 60W lightbulb utilizes 60W of energy to produce the equivalent of 60W of heat and light energy.


2

Which of the following is not a characteristic of a step-up transformer?

54% Answer Correctly

has more turns in the secondary winding than in the primary winding

the secondary voltage is higher than the primary voltage

the primary voltage is higher than the secondary voltage

increases voltage


Solution

As their names indicate, a step-up transformer is used to step up or increase voltage and a step-down transformer is used to step down or decrease voltage. In a step-up transformer, the secondary voltage is higher than the primary voltage and it has more turns in the secondary winding than in the primary winding.


3

The joule is a unit of measurement for:

67% Answer Correctly

resistance

capacitance

energy

power


Solution

The joule is a unit of measurement for energy.


4

The diameter of a number 12 wire is __________ the diameter of a number 6 wire?

52% Answer Correctly

less than

double

triple

more than


Solution

The larger the number the smaller the diameter of the wire. So, the diameter of a number 12 wire is less than the diameter of a number 6 wire.


5 A circuit with a 120-volt power supply is protected by a 15-amp circuit breaker. What is the largest number of watts loads on this circuit can safely use?
85% Answer Correctly
3600 W
1800 W
1980 W
1620 W

Solution
Wattage is current multiplied by voltage: W = IV. So, the maximum amount of power a 120-volt circuit with a 15A circuit breaker would allow is 120V x 15A = 1800 W.