ASVAB Electronics Information Practice Test 361925 Results

Your Results Global Average
Questions 5 5
Correct 0 3.04
Score 0% 61%

Review

1

Inductance is a factor in which of the following?

44% Answer Correctly

determining energy stored by a capacitor

an AC circuit

batteries connected in serial

a DC circuit


Solution

Inductance is a property of an AC circuit (or a component in an AC circuit) that quantifies resistance to changes in current. The current in an AC circuit is continuously changing and inductive reactance (the opposition to change) depends both on the inductance of the circuit or component and the rate at which the current is changing.


2

Which of the following will help to prevent a short circuit?

74% Answer Correctly

transistor

diode

fuse

resistor


Solution

Fuses are thin wires that melt when the current in a circuit exceeds a preset amount. They help prevent short circuits from damaging circuit components when an unusually large current is applied to the circuit, either through component failure or spikes in applied voltage.


3 Use Ohm's Law to calculate the value of current in this circuit if voltage is 360 volts and resistance is 90 Ω.
80% Answer Correctly
5.5 A
4 A
6 A
4.4 A

Solution

Ohm's law specifies the relationship between voltage (V), current (I), and resistance (R) in an electrical circuit: V = IR.

Solved for current, I = \( \frac{V}{R} \) = \( \frac{360}{90} \) = 4 A


4

Which of the following is not a characteristic of a step-up transformer?

54% Answer Correctly

the secondary voltage is higher than the primary voltage

increases voltage

has more turns in the secondary winding than in the primary winding

the primary voltage is higher than the secondary voltage


Solution

As their names indicate, a step-up transformer is used to step up or increase voltage and a step-down transformer is used to step down or decrease voltage. In a step-up transformer, the secondary voltage is higher than the primary voltage and it has more turns in the secondary winding than in the primary winding.


5 How would you connect 6 [15V 20A] batteries to achieve a combined power output of 90V 20A?
53% Answer Correctly
series-parallel
perpendicular
series
parallel

Solution

Connecting the 6 batteries in series multiplies their voltage while keeping their current the same yielding a 90V 20A configuration. Connecting the 6 batteries in parallel multiplies their current while keeping their voltage the same yieleding a 15V 120A configuration. Using a series-parallel connection, 3 batteries can be connected in series and 3 can be connected in parallel resulting in a 45V 60A configuration.