ASVAB Electronics Information Practice Test 390229 Results

Your Results Global Average
Questions 5 5
Correct 0 3.34
Score 0% 67%

Review

1

The joule is a unit of measurement for:

67% Answer Correctly

capacitance

resistance

power

energy


Solution

The joule is a unit of measurement for energy.


2

You would measure the amount of resistance at a certain point in a circuit with a(n):

78% Answer Correctly

voltmeter

potentiometer

ohmmeter

ammeter


Solution

Resistance is opposition to the flow of current and is measured in ohms (Ω). An ohmmeter is used to measure the amount of resistance at a certain point in a circuit.


3

In an electrical circuit, resistors have fixed or __________ resistance.

69% Answer Correctly

dynamic

parallel

series

variable


Solution

Resistors are used to limit voltage and/or current in a circuit and can have a fixed or variable resistance.  Variable resistors (often called potentiometers or rheostats) are used when dynamic control over the voltage/current in a circuit is needed, for example, in a light dimmer or volume control.


4

The most common circuit configuration is:

58% Answer Correctly

series-parallel

household

series

parallel


Solution

Circuits are not limited to only series or only parallel configurations. Most circuits contain a mix of series and parallel segments. A good example is a household circuit breaker. Electrical outlets in each section of the house are wired in parallel with the circuit breaker for that section wired in series making it easy to cut off electricity to the parallel parts of the circuit when needed.


5

What is the primary difference between a rectifier and an inverter?

61% Answer Correctly

a rectifier converts an AC input to DC while an inverter converts a DC input to AC

a rectifier strips out the DC portion of electricity while an inverter strips out the AC portion

a rectifier strips out the AC portion of electricity while an inverter strips out the DC portion

a rectifier converts a DC input to AC while an inverter converts an AC input to DC


Solution

A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.