ASVAB Electronics Information Practice Test 392232 Results

Your Results Global Average
Questions 5 5
Correct 0 2.97
Score 0% 59%

Review

1

Which of the following is not a purpose of a resistor in an electrical circuit?

70% Answer Correctly

multiply the current in the circuit

control the voltage in the circuit

limit the current in the circuit

moderate the heat in the circuit


Solution

Resistors can be chosen in a wide variety of values to control the voltage in a circuit, limit the current, or moderate the heat produced by the components in the circuit.


2

What kind of diode allows current to flow in the opposite direction once a certain voltage threshold is reached?

50% Answer Correctly

standard diode

zener diode

v-type diode

light emitting diode


Solution

A diode allows current to pass easily in one direction and blocks current in the other direction. A zener diode is a diode which allows current to flow in one direction as normal and will also allow current flow in the reverse direction when the voltage is above a certain value. This value is called the breakdown voltage.


3

What is the primary difference between a rectifier and an inverter?

61% Answer Correctly

a rectifier strips out the DC portion of electricity while an inverter strips out the AC portion

a rectifier converts an AC input to DC while an inverter converts a DC input to AC

a rectifier strips out the AC portion of electricity while an inverter strips out the DC portion

a rectifier converts a DC input to AC while an inverter converts an AC input to DC


Solution

A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.


4

Capacitors are charged by what type of current?

64% Answer Correctly

direct

high voltage

low voltage

alternating


Solution

Capacitors store voltage and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors are often used to maintain power within a system when it is disconnected from its primary power source or to smooth out or filter voltage within a circuit.


5 How would you connect 6 [9V 5A] batteries to achieve a combined power output of 9V 30A?
51% Answer Correctly
parallel
orthogonal
perpendicular
series

Solution

Connecting the 6 batteries in series multiplies their voltage while keeping their current the same yielding a 54V 5A configuration. Connecting the 6 batteries in parallel multiplies their current while keeping their voltage the same yieleding a 9V 30A configuration. Using a series-parallel connection, 3 batteries can be connected in series and 3 can be connected in parallel resulting in a 27V 15A configuration.