Resistance is opposition to the flow of current and is measured in ohms (Ω). One ohm is defined as the amount of resistance that will allow one ampere of current to flow if one volt of voltage is applied. As resistance increases, current decreases as resistance and current are inversely proportional.

Semiconductors have valence shells that are exacly half full and can conduct electricity under some conditions but not others. This property makes them useful for the control of electrical current.

You can multiply the voltage or the current supplied by individual batteries by connecting them together either in series or in parallel. The characteristics of batteries connected in parallel are that total voltage equals the average of the individual battery voltages, total current equals the sum of the individual battery currents, the positive terminal of one battery is connected to the positive terminal of the next, the negative terminal of one battery is connected to the negative terminal of the next, and two connections are made between each adjacent battery.

Connecting the 8 batteries in series multiplies their voltage while keeping their current the same yielding a 120V 20A configuration. Connecting the 8 batteries in parallel multiplies their current while keeping their voltage the same yieleding a 15V 160A configuration. Using a series-parallel connection, 4 batteries can be connected in series and 4 can be connected in parallel resulting in a 60V 80A configuration.

In a parallel circuit, each load occupies a separate parallel path in the circuit and the input voltage is fully applied to each path. Unlike a series circuit where current (I) is the same at all points in the circuit, in a parallel circuit, voltage (V) is the same across each parallel branch of the circuit but current differs in each branch depending on the load (resistance) present.