ASVAB Electronics Information Practice Test 405995 Results

Your Results Global Average
Questions 5 5
Correct 0 3.18
Score 0% 64%

Review

1

This circuit component symbol represents a(n):

71% Answer Correctly

capacitor

transistor

diode

inductor


Solution

A diode allows current to pass easily in one direction and blocks current in the other direction. Diodes are commonly used for rectification which is the conversion of alternating current (AC) into direct current (DC). Because a diode only allows current flow in one direction, it will pass either the upper or lower half of AC waves (half-wave rectification) creating pulsating DC. Multiple diodes can be connected together to utilize both halves of the AC signal in full-wave rectification.


2

The volt is a unit of measurement for:

79% Answer Correctly

current

power

capacitance

voltage


Solution

Voltage (V) is the electrical potential difference between two points. Electrons will flow as current from areas of high potential (concentration of electrons) to areas of low potential. Voltage and current are directly proportional in that the higher the voltage applied to a conductor the higher the current that will result.


3

The farad is a unit of measurement for:

63% Answer Correctly

energy

inductance

power

capacitance


Solution

Capacitors store electricity and are used in circuits as temporary batteries. Capacitors are charged by DC current (AC current passes through a capacitor) and that stored charge can later be dissipated into the circuit as needed. Capacitors are often used to maintain power within a system when it is disconnected from its primary power source or to smooth out or filter voltage within a circuit.


4

Which of the following is a characteristic of batteries connected in parallel?

52% Answer Correctly

one connection is made between each adjacent battery

total current equals the sum of the individual battery currents

total current equals the average of the individual battery currents

the positive terminal of one battery is connected to the negative terminal of the next


Solution

You can multiply the voltage or the current supplied by individual batteries by connecting them together either in series or in parallel. The characteristics of batteries connected in parallel are that total voltage equals the average of the individual battery voltages, total current equals the sum of the individual battery currents, the positive terminal of one battery is connected to the positive terminal of the next, the negative terminal of one battery is connected to the negative terminal of the next, and two connections are made between each adjacent battery.


5 How would you connect 6 [6V 15A] batteries to achieve a combined power output of 36V 15A?
53% Answer Correctly
series
perpendicular
parallel
orthogonal

Solution

Connecting the 6 batteries in series multiplies their voltage while keeping their current the same yielding a 36V 15A configuration. Connecting the 6 batteries in parallel multiplies their current while keeping their voltage the same yieleding a 6V 90A configuration. Using a series-parallel connection, 3 batteries can be connected in series and 3 can be connected in parallel resulting in a 18V 45A configuration.